Saturday, March 17, 2018

How to Make Southwest Easter Eggs






I was scrolling through Pinterest recently (looking for inspiration for this year's Easter eggs) when I stumbled upon an adorable set of cactus themed egg topiaries.  It didn't look like they would be too hard to recreate, so after a quick trip to Dollar Tree I was all set to get started! 
Read on to see how easy this project was to complete:

Disclosure- This post contains affiliate links.  If a purchase is made through an affiliate link then (at no additional cost to you) I will receive a commission.  Affiliate links are noted below.



Supplies

For this project I used foam eggs, miniature terra cotta pots, decorative stones and craft foam.  

The foam eggs I had left over from previous years, but you can find them at Wal-Mart for about $2 a dozen.  The remaining supplies were purchased at Dollar Tree.



Step 1

  
I chose three different shades of green paint to create interest in the finished grouping, but a single shade will do as well.  I already had this acrylic paint on hand, but it can be purchased at any craft store if needed.

Tip:  I recommend painting your eggs right away so that they can begin drying.  



Step 2

Cut the foam squares into smaller pieces to fit the pots that you are using.  I was able to cut one square of foam into enough pieces for all six of my pots, it doesn't take a whole lot.

Once cut, my foam pieces were a tight enough squeeze that no glue was needed, but feel free to add some if you notice any wiggle room.  Also, I made sure that the pieces were short enough that they sat a bit lower than the rim of the pots.  This bit of depth will give your stones a nice place to settle.



Step 3


After my foam was tucked in I began to fill in the space with the decorative stones using hot glue.

 You can leave a small hollow in the center as that is where the base of the egg will settled.  And d
on't get too worried about the gaps in between the stones, that will all be covered up in a moment.



Step 4

Using more glue, fill in those gaps with a bits and pieces of decorative moss.  
(The moss is another item that I had on hand but can be purchased at most craft stores)



Step 5

I used a Sharpie to free hand a few simple designs on the eggs.  These can be as realistic or as whimsical as you wish - I went in the whimsical direction 😊



Step 6

Once your 'cacti' are detailed, glue the bottom (the widest part) of the egg into the mossy nest.  



Step 7

I decided to embellish a few of the cacti using some tiny artificial flowers that I had on hand.  And there you have it:  southwest Easter eggs!

**********

I love how these southwest Easter eggs turned out and was especially pleased that nearly all of the supplies were found at my local Dollar Tree.

Want to check out Dollar Tree's merchandise for yourself?

Click the affiliate link below and happy shopping!
Easter Crafts, Supplies, and More At Dollar Tree!

**********

I hope you enjoyed this how-to post, thanks for stopping by!
-Jennifer

© Jennifer Adams Flowers 2018

No comments:

Post a Comment